The basics of getting a good radiator flush

One of the most vital of components of any car is that of the radiator. This is because it is an element that acts as a cooling system. This is a device that must be cleaned and must also be free of any dirt and obstacles so that it functions effectively. However it is a pity that many drivers overlook the radiator until something really happens. That is why there are a number of problems associated with radiators for most cars. It is therefore important that appreciates the importance and basics of a good radiator flush for your car.

Parking for a radiator flush

When it comes to the directions to be used for your radiator flush, one must ensure that the car is parked on a surface that is flat while the engine is turned off with the heater on. Also make sure that the engine is covered to shield it from splashes and then take out the radiator. Let the water come out by turning the tap at its bottom while the lower and upper hoses are disconnected and then inspected. You would have to examine the old liquid that comes out of the radiator. If this is dirty and rusty, this system would require a special kind of flushing.

For your radiator flush, there should be a water hose placed at the top part of the radiator. This should then be used to gently flush the device for some time so that the water would run clean. You would then have to put this in the reverse flush and then the bottom part of the radiator outlet. This must then be flushed from the top part again. Make sure that you take out any form of dirt or deposits by the flushing of the cooling jacket of the engine.

When the radiator flush has been completed, you can now close the radiator by refitting the hoses and filling the radiator with the coolant. Make sure that you check for the condition of the radiator cap before you choose to put in a new one when the old one has rusted. Check for any leaks in the radiator by starting the engine and letting it run for some time. When the engine has cooled down, you can check the coolant level to see if it requires a topping up.

radiator flushFor tips regarding the radiator flush, the best thing to do would be to take it to a mechanic to get an exchange unit or for repairs when there is a leak somewhere. As much as possible there should be a radiator flush after every 6 months which would go a long way to prevent any kind of obstacles. For those radiators that have leaks, one should go in for a leak sealer can. This must then be put in the coolant even though it is a temporary measure for small leaks. You must ensure that the radiator that is non-sealed is checked on a regular basis and then cleared of any leaves available.